a) Normally the Smart Press is mounted directly on the delivery point of a surface pump: the device is connected with a 1" male connector, however it can be mounted at any point on the delivery piping (even on a submerged pump) in a vertical or horizontal position. Avoid applying check valves downstream from the appliance, whereas application upstream is recommended.
b) The Smart Press delivery should be connected to the water supply (1¼" female). It is recommended to use a flexible hose to prevent damage from tightening and/or vibration.
c) The standard model of Smart Press works correctly if the highest point of use is not higher than 15 meters. Change this value using the setting screw (dowel) on the front of the Smart Press. Turn the screw clockwise to increase the ignition value. Turn counterclockwise to reduce the ignition value.
d) Make sure that the pump primes perfectly by filling the body of the pump and suction hose with water. If the pump is going to be used with supply from a low level (well), always install a foot valve.
e) Perform electric connection observing the screen-printing on the electronic card located in front of the clamps.
We recommend you read the instruction manual of the Smart Press (also available in our DNA software) for all information.
